Loading page
We use analytics to understand site visits. Declining won't change your experience.
We use Meta and Google Analytics to understand how visitors use JTC. Declining means we won't track your visit — the store works exactly the same either way.
Automatically controls your pump based on overhead tank level, with dry-run protection, voltage protection, and a clear 16×2 LCD display.
Four-level overhead tank sensing (25/50/75/100%), optional underground tank dry-run sensor, three operating modes, and a 6-page report screen showing run time, cycle counts, and estimated electricity cost.
৳8,500
The JTC M2306 runs the same proven hardware as the 2306Ai — ATmega328P microcontroller, four-level tank sensing, and built-in voltage protection — without the AI learning features. It starts and stops your pump automatically based on the overhead tank level and protects against dry-running and bad mains voltage.
The 16×2 LCD shows water levels, voltage, current mode, and run duration at a glance. A 6-page Report Mode gives you total run minutes, start/stop cycle counts, total kWh consumed, and an estimated electricity bill — calculated from your configured motor wattage and per-unit rate.
Stops the motor if the underground tank runs empty. Configurable detection and retry timers prevent pump damage.
Independently configurable low and high voltage cutoffs protect your pump from bad mains supply.
Configurable continuous run-time limit stops the motor even if every sensor still reads correctly.
Dedicated test mode shows raw state of every OHT and UGT sensor plus current AC voltage and relay state.
Total run minutes, start/stop cycles, kWh and estimated electricity bill, plus current mode status.
The M2306 uses the same hardware and firmware platform but does not include the AI Auto Cut-Off feature — the learned fill/drain detection that flags a stalled fill. If you need the controller to learn your tank's normal fill time and alert you when something changes, choose the 2306Ai. If you want the same proven protection without the learning features, the M2306 is the right choice.
Yes. The underground tank sensor input is optional. When disabled, those same pins can be configured as a water-flow detection input instead.
The controller restarts automatically when power returns. The PwrOn<75% Start option lets you choose whether the pump auto-starts only if the tank was below 75% — preventing unnecessary top-ups after a brief outage. A 24-hour self-restart is built in as a normal operating behaviour.
Same hardware, same safety — the M2306 gives you everything the 2306Ai offers except the AI learning features.
৳8,500
Run your pump manually in SEMI-AUTO or MANUAL mode with full safety protection still active.